Miele B 3312 Operating Instructions Manual page 73

Message

Inlet fault, boiler
Switch off/on

Press. switch fault
Switch off/on

Boiler fault, warm
Switch off/on
Possible cause and remedy
There is a fault with the steam system.
 Press the  button to switch the steam ironing
system off and then back on again.
After the cool-down phase, the steam ironing system
will carry out a rinse and attempt to correct the fault
itself. The cool-down phase can take up to 3 hours.
 Remove the residual water drawer if you are
prompted to do so by the appropriate message in
the display.
 Empty and dry the residual water drawer.
 Push the residual water drawer back in the tower
until it clicks into place.
There is a fault with the steam ironing system.
 If the fault message continues to be displayed,
contact Miele.
There is a fault with the steam system.
 Press the  button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact
Miele.
There is a fault with the steam ironing system.
 Press the  button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact
Miele.
The steam generator is soiled with water containing
too much limescale or salt.
 Start a descaling process (see "Starting the
descaling process early"). To avoid this problem in
the future, the preset water hardness level can be
set one level higher (e.g. from
"Setting the water hardness").
 If the fault continues to be displayed, contact
Miele.
Problem solving guide
Level 4 to Level 5 , see
73