Miele B 3312 Operating Instructions Manual page 68

Problem solving guide
Problem
The ironing board
cannot be set in the
final position during
assembly or
dismantling.
The iron does not heat
up.
68
Possible cause and remedy
The ironing board became dislodged from the
latching mechanism when the board was not in its
lowest position.

The resting surface of the iron remains hot
after ironing.
Danger of burning!
Switch off at the wall socket and withdraw the
plug. Let the iron and the resting surface cool
down before removing the iron from the resting
surface, and proceed with the following steps.
 Press and hold the release button on the tower
().
 At the same time, turn one of the rotary dials on
the side of the tower as far as it will go in the
direction of  and hold the dial in this position ().
 Push the tower down as far as possible ().
 Then let go of the rotary dial on the side and
subsequently release the unlocking button on the
tower.
Now the ironing board can either be folded away or
brought into its working position.
 If the ironing board still will not lock into place,
contact Miele.
The steam ironing system is switched off.
 Use the  button on the control panel to switch
the steam ironing system on.
The steam hose is not plugged in properly.