Miele B 3312 Operating Instructions Manual page 54

Cleaning and care
 Empty drawer
This message may be displayed after
inserting the water container with the
descaling tablet. If you do not see this
message, you can skip the following
steps and continue as soon as you
see  Pre-rinse in the display.
 Set the steam ironing system to its
highest working position in order to
remove the residual water drawer
(see "Assembling - Adjusting the
height").
 Remove the residual water drawer
from the tower.
The residual water drawer may still
be warm after the rinsing process.
 Empty the residual water drawer.
As long as the residual water drawer is
not inserted into the tower, the display
will show the following message 
drawer .
 Fit drawer
 Slide the residual water drawer back
into the tower until it clicks into place.
54
 Pre-rinse
If the steam ironing system is still hot
from the previous use, the cooling
down phase will start first. This may
take up to 3 hours.
The pre-rinse phase then follows
(duration approx. 20 minutes). During
this time, a portion of the descaling
solution is pumped into the steam
generator.
After the pre-rinse phase you will be
prompted to carry out further actions.
This will be shown for a few seconds
before the pre-rinse phase starts and
will be indicated by the message 
20 min. 
Fit
.
In