Ground - Directechs DB3 Installation Manual

Vehicle Takeover
NO vehicle takeover available for Push-to-Start (PTS) models. The engine will stop
when a door is opened.
Wait at least 2 seconds before restarting the engine or an error message may appear in
the vehicle information display.
Pit Stop Mode
The Pit Stop Mode feature is practical when you need to stop and run an errand,
but wish to keep the engine running.
Stop the vehicle in a safe parking spot
1
and put the gear in Park (P). On manual
transmission vehicle, open the driver door.
Press the Remote Start button on the transmitter.*
2
The parking lights will flash once to indicate the
vehicle is now in Pit Stop Mode.
3 Key-type vehicles: Turn ignition OFF. Remove the
key from the ignition barrel.
It is now safe to leave the engine running
and exit the vehicle with the remote or key
in hand.
4
Note: We recommend that you always lock
the doors of your vehicle when leaving it unattended.
* Your aftermarket remote may differ from the model shown in the illustrations.
19
List of Available Commands
Note that the information below is for Viper, Clifford and Python models. Icons and
commands may differ depending on the remote brand and model purchased. Refer
to your authorized installation center for more information.
P
&
Stop & put vehicle in Park (P)
Press
remote start
button*
Key OUT
START
* This output is configurable. see your authorized installation center for more
information.
OR
Exit vehicle
with Remote
Button(s) Actions
Press & hold for 1 second to lock.
Press & hold for 1 second to unlock.
Press & hold for 1 second to remote
start.
Press & hold for 5 seconds to activate
the trunk release (optional).
Press
x1 +
rear hatch/tail glass release (optional).*
Press
x3 +
the panic mode.
Press
x1 +
remote starter runtime.
once, then to activate the
3 times, then to activate
once, then to reset the
403.HONDA7 2.19 2016 Honda Civic (Smart Key)
© 2016-11-30 Directed. All rights reserved.