ABB REM 610 Technical Reference Manual page 86

REM 610 REM 610
Description
Trip target code
Start-up time of the latest motor start
up
Number of pickups of element 48/14
Number of pickups of element 50P-1
Number of pickups of element 51N
Number of pickups of element 37
Number of pickups of element 46
a)
During motor start up, the value 16383 will be returned, indicating that the current value is not available.
b)
During motor start up, the value 13107 will be returned, indicating that the current value is not available.
Table 5.1.14.1.-13 Mapping of Modbus data: control points
Description
LED reset
a)
Coil area, only writeable.
86
Motor Protection Relay
Technical Reference Manual - ANSI Version
HR/IR address
(.bit)
814
815
816
817
818
819
820
HR/IR address
(.bit)
Structure 1
The status registers contain information on unread fault and event records, and relay
status. The registers are arranged as in Fig. 5.1.14.1.-2 below.
15
401
Reserved
402
403
FR ER
Fig. 5.1.14.1.-2 Status registers
When the value of the FR/ER bit is 1, there is one or several unread fault/event
records. If time synchronization is realized via a digital input, either the SP (second-
pulse) or MP (minute-pulse) bit will be activated.
Refer to Table 5.1.16.-1 for IRF codes and Table 5.1.16.-2 for warning codes.
Structure 2
This structure contains data recorded during a fault sequence. Refer to Fault records
earlier in this section for the reading method.
DI/Coil bit Writeable
address
DI/Coil bit Writeable
address
501 W
8 7
Warning code
Reserved
1MRS755537
Value range Comment
0...21 See Table 5.1.15.-
2
0...240 Seconds
0...999 Counter
0...999 Counter
0...999 Counter
0...999 Counter
0...999 Counter
Value range Comment
1 1 = LED reset
0
IRF code
SP MP
a)
A040333