ABB REM 610 Technical Reference Manual page 108

REM 610 REM 610
108
Motor Protection Relay
Technical Reference Manual - ANSI Version
Table 5.1.16.-1 IRF codes
Fault code Type of fault
4 Error in output relay PO1
5 Error in output relay PO2
6 Error in output relay PO3
7 Error in output relay SO1
8 Error in output relay SO2
9 Error in the enable signal for output relay PO1, PO2, SO1 or SO2
10, 11, 12 Error in the feedback, enable signal or output relay PO1, PO2, SO1
or SO2
20, 21 Auxiliary voltage dip
30 Faulty program memory
50, 59 Faulty work memory
a)
51, 52, 53 , 54, 56 Faulty parameter memory
55 Faulty parameter memory, calibration parameters
75 RTD module faulty
80 RTD module missing
81 RTD module unknown
82 RTD module configuration error
85 Power supply module faulty
86 Power supply module unknown
90 Hardware configuration error
95 Communication module unknown
104 Faulty configuration set (for IEC 60870-5-103)
131, 139, 195, 203, Internal reference voltage error
222, 223
253 Error in the measuring unit
a)
Can be corrected by restoring factory settings for CPU.
b)
All settings will be zero during the fault.
For further information on internal relay faults, refer to the Operator's Manual.
Warnings
In case of a warning, the relay continues to operate except for those protection
functions possibly affected by the fault, and the green target LED (ready) remains lit
as during normal operation. Further, a fault target message, which depending on the
type of fault includes a fault code, appears on the LCD. If more than one type of
fault occur at the same time, one single numeric code which indicates all the faults is
displayed. The fault target message cannot be manually cleared but it disappears
with the fault.
When a fault appears, the fault target message is to be recorded and stated when
ordering service. The fault codes are listed in the following table:
b)
1MRS755537