Table of Contents
Advertisement
Vertical Termination with Co-Linear Flex System
The appliance must not be connected to a chimney flue
serving a separate solid fuel burning appliance.
Masonry chimneys may take various contours which the flexible liner
will accommodate. However, keep the flexible liner as straight as
possible, avoid unnecessary bending.
The Air Intake pipe must be attached to the inlet air collar of the
termination cap.
This appliance is designed to be attached to two 3" (76mm) co-linear
aluminium flex running the full length of the chimney. See the Venting
Arrangements for minimum and maximum heights.
Vertical Termination
A maximum
of two certified
joiner kits
may be used
per length.
#948-305 (35 ft)
Exhaust
Flue
Outer
Pipe
with Kit#
946-563
Pipe Length
Rigid Pipe Adapter
# 510-994
90 Degree
Elbow
Co-linear DV
Cap # 946-529
Flex Liner
Inner Pipe
Adapter
with Kit#
946-563
Gas Fireplaces
Required Parts:
Part #
946-529
948-305
946-563
510-994
46dva-E45
Alternate Approved Caps
46dva-VC
46dva-VCH
46dva-GK
Air Intake
Co-Linear
Flex
Adapter
with Kit#
946-563
Description
Co-linear DV Vertical Termination Cap
3" Flex - 35 ft.
Coaxial to Co-linear Adapter Kit which contains
the following: Co-linear Flex Adapter Outer Pipe
Inner Pipe Adapter
Flue Adapter
45º Elbow
Vertical Termination Cap
High Wind Cap
3" Co-linear Adapter with flashing
30
Horizontal Distance (Feet)
The shaded area in the diagrams
show the allowable vertical
terminations.
Please refer to Exterior
Vent Terminations for
additional guidelines on
vent locations.
P36D Gas Fireplace
Advertisement
Table of Contents
