Available Options - Atlas Copco XAMS 407 CD Instruction Manual

Available options

Support
A rigid support mounted version for rough
construction conditions with the possibility to be
mounted on a truck. The installation allows the unit to
be put on and taken off the truck daily. It is possible
to handle the unit with a forklift.
Fix height towbar with brakes
A fix towbar with integrated parking brake.
Adjustable height towbar with brakes
A dual-hinged articulating towbar assembly, with
integrated parking brake.
DIN/NATO/ITA eye
Towing eye according to DIN, NATO or ITA
specification.
Road signalization
A road signalisation option compliant with European
regulations. The rear lights are protected by the
canopy or the bumper bar against external damage.
Road signalization USA
Additional side mounted lights to meet North
American road signalization requirements.
SCANDIC cold weather package (to -10°C)
The SCANDIC cold weather package consist of a
heater plug, installed in the air-inlet to the engine, a
dual approved vessel (EC/ASME) for which the
material is approved and certified up to –29°C, and a
blow-off valve on the vessel to minimise the
resistance from the oil in the vessel when starting at
extreme cold-temperatures.
compressor oil is used to improve viscosity at low
temperatures.
NORDIC cold weather package (-10°C to –
25°C) - OTM only
The NORDIC cold weather package consist of a
preheater installation in combination with the
SCANDIC cold weather package (-10°C).This option
includes a coolant heater; an engine-independent
water heater.
The installation works on battery voltage and comes
together with a timer function. A 5000 Watt heater
will heat up the engine coolant by means of
consuming the onboard fuel. (fuel consumption: 0.62
l/h in operation, water pump capacity: +/- 900 l/h).
The undercarriage is adapted due to the increased
weight.
- 69 -
ARCTIC cold start package (-25°C to –30°C) -
OTM only
The ARCTIC cold weather package is a combination
of the NORDIC cold weather package (-25°C) and an
electric engine preheater to keep the engine coolant
on constant temperature and circulating by build-in
pump (power supply 230VAC 1500W). Also
Also synthetic additional insulation, heating pads and an aftercooler
bypass are installed.
Aftercooler + Water separator
The aftercooler
temperature to ambient + 10°C.
On units with a cold weather option a bypass on the
aftercooler is standard.
Fine Filter (PD)
The fine-filter package completes the after cooler
option. It removes particles and oil content down to
3
0.01 mg/m
be done without dismounting other parts or canopy.
Active Coalescing Filter (QD)
For improved quality air an additional oil vapour and
odour filter is available reducing the oil content to a
maximum of 0.003 mg/m
option can be serviced without dismounting other
parts or canopy.
reduces the discharging
. Service and replacement of the filter can
3
. The active coal filter pack
air