Oil Specifications; Compressor Oil - Atlas Copco XAMS 407 CD Instruction Manual

OIL SPECIFICATIONS

It is strongly recommended to use Atlas
Copco branded lubrication oils for both
compressor and engine.
Only use mineral based compressor oil
PAROIL M in XAMS 407 CD - XAMS
850 CD7, XATS 377 CD - XATS 800
CD7, XAHS 347 CD - XAHS 710 CD7
and XAVS 307 CD - XAVS 650 CD7.
High-quality, mineral, hydraulic or synthesized
hydrocarbon oil with rust and oxidation inhibitors,
anti-foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient
temperature and ISO 3448, as follows:
Never mix synthetic with mineral oil.
Remark:
When changing from
synthetic oil (or the other way around),
you will need to do an extra rinse:
After doing the complete
procedure to synthetic oil, run the unit
for a few minutes to allow good and
complete circulation of the synthetic oil.
Then drain the synthetic oil again and
fill again with new synthetic oil. To set
correct oil levels, proceed as in normal
instruction.
Type of lubricant
between 30°C and 40°C
between -5°C and 30°C
between -20°C and -5°C

COMPRESSOR OIL

Synthetic compressor oil PAROIL S
can
can
barrel
container
mineral to
Mineral compressor oil PAROIL M
change
can
can
barrel
Synthetic compressor oil PAROIL S68
can
barrel
Compressor
PAROIL S
PAROIL M
PAROIL S
PAROIL S
Liter
5
20
210
1000
Liter
5
20
210
Liter
20
210
- 47 -
Engine
PAROIL 15W40
PAROIL 15W40
PAROIL 5W30
US gal Order number
1.3 1615 5950 01
5.3 1615 5951 01
55.2 1615 5952 01
265 1604 7422 00
US gal Order number
1.3 1615 5947 00
5.3 1615 5948 00
55.2 1615 5949 00
US gal Order number
5.3 1604 7136 00
55.2 1604 7137 00