Installing the system fan
1
Place the system fan on the system board and align the system fan on the screw holders.
2
Tighten the M2.0x3.0 screws to secure the heat sink to the system board.
3
Connect the fan cable to the connector on the system board.
4
Install the:
a
battery
b
base cover
5
Follow the procedure in
Power connector port
Removing the power connector port
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
3
To remove the power connector port:
a
Disconnect the power connector port cable from the connector on the system board [1].
NOTE:
Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in breakage.
b Remove the M2.0x3.0 screw to release the metal bracket that secures the power connector port [2].
c
Remove the metal bracket that secures the power connector port [3].
d Lift the power connector port away from the laptop [4].
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
29