Installing the battery
NOTE:
68Whr battery can use either a M.2 or 7mm SATA drive.
1
Insert the battery into the slot on the laptop.
NOTE:
Wrap the battery cable below the battery routing channel to enable proper connection to the connector.
2
Connect the battery cable to the connector on the system board.
3
Tighten the M2x5 screw to secure the battery to the laptop.
4
Install the
base
cover.
5
Follow the procedure in
Solid State Drive — optional
Removing the M.2 Solid State Drive - SSD
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
3
To remove the SSD:
a
Remove the M2.0x3.0 screw (1) that secures the SSD bracket to the laptop and lift the SSD bracket that secures the SSD card
to the system board [1],[2] .
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
15