Table of Contents
Advertisement
2. Install the:
a.
palmrest
b.
battery
c.
base cover
d.
SD card
3. Follow the procedure in
Power connector port
Removing the power connector port
1. Follow the procedure in
2. Remove the:
a.
SD card
b.
base cover
c.
battery
3. To remove power connector port:
a. Disconnect the power connector cable from the connector on the power daughter-board [1].
b. Peel the adhesive tape that secures the power connector cable to the system and unroute the cable [2, 3].
48
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
