Powerware Ferrups FE/QFE 500VA Installation Manual page 38

External Bypass Switch Installation
To prevent electrical shock or damage to your equipment, verify that the UPS ON/OFF
switch is in the OFF position before you remove the UPS front cover panel. The circuit
breaker or disconnect switch must be turned off at the AC input service panel.
5. Remove the UPS front cover panel according to the UPS model:
6. Remove the knockouts in the UPS rear panel for AC Input and
7. Install the conduit adapters. AC Input and AC Output
To prevent electrical shock or damage to your equipment, verify that the AC input is
OFF at the service panel and the bypass and AC disconnect switches are in the OFF
position before you connect any wires to the bypass switch terminal strip.
32
Powerware
C A U T I O N
FE or QFE 500 VA–3.1 kVA
: Remove the #1 Phillips grounding screw on top of the UPS.
: Remove and save the sticker in the lower right corner of the
UPS front cover panel with the Powerware logo.
: Use a #2 Phillips screwdriver to loosen (but not remove) the
screw.
: Slide the UPS front cover panel forward until it is completely
off the UPS.
FE or QFE 4.3–18 kVA
: Remove the screws on the UPS side panels using a Phillips
screwdriver.
: Loosen (but do not remove) the three Phillips screws on the
bar across the top of the UPS.
: Slide the top of the UPS side panels out.
: Lift the panels to remove them.
AC Output. If your UPS has a separate battery cabinet, also
remove the knockout for DC.
conductors must be run through separate pieces of conduit.
UPS output circuits shall be installed in dedicated conduit
systems and not shared with other electrical circuits.
C A U T I O N
® FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide
:
Rev A www.powerware.com