Bypass Switches - Powerware Ferrups FE/QFE 500VA Installation Manual

Electrical Installation

Bypass Switches

Bypass switches are available in two types: external (a separate cabinet
that is wall-mounted) or internal (attached to the back of the UPS). The
bypass switch has three positions as described in Table 6.
Table 6. Bypass Switch Positions
Switch Position Description
LINE
OFF
UPS
NOTE In all three positions, AC input power is still connected to the input terminals
inside the UPS (once the UPS is installed). Use the AC disconnect switch (located on
the right side of the bypass switch) to disconnect AC input power during maintenance
or service.
Bypass switches may be MBB or BBM.
An MBB switch makes a new connection before it breaks the original
connection. For example, if you turn an MBB switch from UPS to LINE,
the bypass switch connects the load to AC input power before
disconnecting the load from UPS output power.
NOTE MBB switches are not for use with 208 Vac.
A BBM switch breaks the original connection before it makes a new one.
If you turn a BBM switch from UPS to LINE, the switch disconnects the
load from UPS output power before connecting the load to AC input
power.
24
Powerware
Connects the load directly to AC input power and disconnects UPS output.
AC input power is still connected to the UPS input.
Disconnects the load from the UPS output power and AC input power.
Connects the UPS output to the load.
® FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide
:
Rev A www.powerware.com