Making Wi-Fi Settings By Push Button Setup - Epson ET-2700 Series User Manual

User's Guide

Making Wi-Fi Settings by Push Button Setup

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
2. Press the button on the printer until the
seconds).
The connection setting will start. When a connection is established, the
Note:
The printer is in a connection error status when the
the printer error by pressing the
again. If it still does not work, print a network connection report and check the solution.
Related Information
"Checking the Network Connection Status" on page 22
&
"Printing a Network Connection Report" on page 22
&
Network Settings
light and the
light and the
button on the printer, reboot the access point, place it close to the printer and try
19
light flash alternately (approximately 3
light turns on.
light flash simultaneously. After clearing