Table of Contents
Advertisement
Installation Guidelines
Installing the front connector (on all I/Os except the 463 analog input module)
Install the front connector as follows :
1. Open the front door of the module.
2. Hook the front connector into the pivot at the bottom of the module.
3. Swing the front connector up and in until it engages with the module.
4. Tighten the screw at the top of the front connector to secure it.
5. Close the front door of the module
Installing the front connector of the 463 analog input module
Proceed as follows:
1. Unscrew the connector cover.
2. Hook the front connector into the pivot at the bottom of the module.
3. Swing the front connector up and in until it engages with the module.
4. Tighten the screw at the top of the front connector to secure it.
5. Screw on the connector cover.
3-30
Figure 3-28. Installing Front Connector
S5-115F Manual
Module
Front door is open
Front connector is swung
up and in
Screw
Pivot
EWA 4NEB 811 6148-02
Advertisement
Table of Contents
