Table of Contents
Advertisement
S5-115F Manual
Possible configurations on mounting rack CR 700-0 (6ES5 700-0LB11)
The CR 700-0 mounting rack is suitable for installing smaller controls.
You can also use adapter casings with two printed circuit boards in the case of the CR 700-0
(6ES5 700-0LB11) mounting rack. There are also slots available for a power supply module (PS), a
central processing unit (CPU), digital and analog block-type modules, the CP 523 communications
processor and interface modules for expansion units.
Steckplätze
Power Supply Module
Central Processing Unit
Digital Module
Analog Module AE 460, AA 470
Analog Module AE 463
CP 523
IM 306, centralized config
IM 304, distributed config
IM 304 / 324,parallel link
Only with the 6ES5 491-0LB11 adapter casing
*
Only the 6ES5 491-0LB11 adapter casing can be used in these slots.
1 The central rack is supplied with a termination connector in this slot. It can stay in this slot if you use the central rack
without expansion racks. This assigns fixed initial module addresses to the slots in the central rack ( 5.2).
Figure 3-3. Possible Configurations on Mounting Rack CR 700-0
EWA 4NEB 811 6148-02
Mounting rack
CR 700-0LB
PS
CPU
0
1
*
Installation Guidelines
1
2
3
IM
*
3-3
Advertisement
Table of Contents
