Forcing Domestic Hot Water Production; Setting The Contrast And Lighting On The Display - DeDietrich AWHP-2 MIT-IN-2 iSystem User Manual

5. Operating the appliance
MODE Menu
Parameter Adjustment range Description
COLD
MANUEL
ON / OFF
(2)
FORCE AUTO
(1) The start and end days and the number of days are calculated in relation to each other.
(2) The parameter is only displayed if a room sensor is connected.
r Menu
Parameter Description
AUTOMATIQUE The domestic hot water comfort ranges are determined by the timer programme.
Domestic hot water comfort mode is forced until the time indicated or all the time (7/7). Present time + 1 hour
COMFORT
0 2 4 6 8
E 1
2
1
D
2
bar
F
# 
AUTO % $
J I
STD
27
Cooling mode is forced.
The generator operates according to the set point setting. All of
the pumps operate. Option of setting the set point by simply
turning the rotary button.
An operating mode override is activated on the remote control
(option).
To force all circuits to run on AUTOMATIQUE mode, select ON.
MODE
C002268-A
10 12 14 16 18 20 22 24
SUNDAY 11:45
!
< :
C002219-D-04
5.3.3.

Forcing domestic hot water production

To force domestic hot water production, proceed as follows:
1. Press the r key.
2. To select the desired parameter, turn the rotary button.
3. To modify the parameter, press the rotary button.
To go back to the previous display, press the key j .
4. To modify the parameter, turn the rotary button.
5. To confirm, press the rotary button.
To cancel, press key h .
5.3.4. Setting the contrast and lighting on the
display
1. To access user level: Press the > key.
2. Select the menu #SETTING.
Turn the rotary button to scroll through the menus or
4
modify a value.
Press the rotary button to access the selected menu
4
or confirm a value modification.
¼ For a detailed explanation of menu browsing, refer to
the chapter: "Browsing in the menus", page 21.
3. Set the following parameters:
AWHP-2 MIT-IN-2 iSystem
Factory setting
Factory setting
10/06/2015 - 7616372-001-05