Sd Memory Cards; Models And Specifications; Purpose - Omron NX701-1700 User Manual

3 Configuration Units
3-2

SD Memory Cards

This section describes the models, specifications, and application of the SD Memory Cards.
3-2-1

Models and Specifications

SD cards and SDHC cards are supported, but use one of the following OMRON Cards. OMRON is not
responsible for the operation, performance, or write life of any other SD or SDHC card.
Model
HMC-SD291
HMC-SD491
Precautions for Correct Use
When you use the SD Memory Card that "MR" is displayed on the back side with an
NX701- CPU Unit, be sure to use the unit version 1.14 or later.
Additional Information
Write Protection Key
You will not be able to write to the SD Memory Card if the key is set to the LOCK position. Use
this setting to prevent overwriting.
3-2-2

Purpose

You can use the SD Memory Card for the following applications.
• Read and write files in the SD Memory Card with instructions.
• Read and write files in the SD Memory Card from an FTP client on EtherNet/IP.
• Back up, restore, and verify data in the Controller.
• Transfer data from the SD Memory Card to the Controller when the power is turned ON.
Refer to the NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501) for details on the func-
tions for SD Memory Cards.
3 - 10
Capacity
Card type
[GB]
SD Card
SDHC Card
Number of over-
Format
2 FAT16 100,000
4 FAT32
NX-series CPU Unit Hardware User's Manual (W535)
Weight
writes
2 g max.