Preparations For Installation - Omron NX701-1700 User Manual

4 Installation and Wiring
4-3-2

Preparations for Installation

We recommend using the following products to install the Unit on a DIN Track.
Name
35-mm DIN Track
End Plate
Not all of the combinations of the DIN Tracks and End Plates listed above are possible.
Confirm applicability of the combinations in the following table.
DIN Track model
PFP-50N
PFP-100N
NS 35/ 7,5 PERF
NS 35/ 15 PERF
Also, use screws and washers of the following sizes to fix the DIN Tracks.
(a): Dimensions from the screw head to the fastening surface
DIN Track model
PFP-50N
NS 35/ 7,5 PERF
NS 35/ 15 PERF
If you use any DIN Track other than those listed in the table above, refer to the dimensions shown in
4-3-8 Assembled Appearance and Dimensions on page 4-29 and use proper screws and washers.
4 - 14
Model
PFP-50N OMRON Corporation
PFP-100N OMRON Corporation
NS 35/ 7,5 PERF Phoenix Contact
NS 35/ 15 PERF Phoenix Contact
PFP-M OMRON Corporation
CLIPFIX 35 Phoenix Contact
PFP-M
(OMRON)
Possible.
Possible.
Possible.
Not possible.
Applicable
screw size
M4 4.1 mm max.
M6 4.6 mm max.
M6 10 mm max.
Manufacturer
• Length: 50 cm
• Material: Aluminum
• Surface treatment: Insulated
• Length: 100 cm
• Material: Aluminum
• Surface treatment: Insulated
• Length: 75.5, 95.5, 115.5, or 200
cm
• Material: Steel
• Surface treatment: Conductive
• Length: 75.5, 95.5, 115.5, or 200
cm
• Material: Steel
• Surface treatment: Conductive
Two End Plates are required for
each CPU Rack.
Two End Plates are required for
each CPU Rack.
Possible.
Possible.
Possible.
Possible.
(a)
(a)
NX-series CPU Unit Hardware User's Manual (W535)
Remarks
CLIPFIX 35
(Phoenix Contact)