Configuring Region Exiting Detection - HIKVISION UD06695B User Manual

User Manual of Network Speed Dome
3. Select the region from the dropdown list for detection settings.
4. Click the
5. Click on the live video to specify the four vertexes of the detection region, and right click to
complete drawing.
Repeat the step to configure other regions. You can click the
pre-defined regions.
6. Set the detection target for the region entrance detection. You can select human, vehicle, or
all (human &vehicle) as the detection target from the dropdown list. If Human is selected,
only human beings will be identified as detection objects and as well as Vehicle.
7. Click
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to Section 5.2.1 Configuring Motion Detection.
8. Click
Notify surveillance center, send email, upload to FTP, trigger channel, smart tracking and
trigger alarm output are selectable. Refer to Section 5.2.1 Configuring Motion Detection.
9. Click

5.3.6 Configuring Region Exiting Detection

Purpose:
Region exiting detection function detects people, vehicle or other objects which exit from a
pre-defined virtual region, and some certain actions can be taken when the alarm is triggered.
© Hikvision
Figure 5-25 Configuring Region Entrance Detection
button to start the region drawing.
tab to enter the arming schedule setting interface. The time
tab to select the linkage method taken for the video loss alarm,
to save the settings.
55
button to clear all