Network Mobile Camera·Quick Start Guide
3. Prepare the screws: Thread the provided bolt through the spring
leaves and the flat gaskets in order.
Bolt
4. Disassemble the camera: Loosen and take off the four screws on
the camera cover, and separate the cover from the mounting base.
As shown in the Figure 2-3.
5. Align the mounting holes on the mounting base with the holes on
the mounting surface, and insert the prepared screws (see step 2)
into the holes.
+
+
Spring Leaf
Figure 2-2
Preparing the Screws
Figure 2-3
Disassemble the Camera
Flat Gasket
Camera Cover
Mounting Base
15