Meyra Sprint Special Operating Instructions page 12

UNIVERSAL INTERFACE
Assembly:
Depending on the wheelchair configuration or customer requirements, the interface box can be posi-
tioned as follows:
– on the back section,
– under the seat (without electric adjustments),
– on the inside or outside of the side section (depending on the side section and the customer's seat position)
– behind the plastic cover between the rear lights (in the case of sprint models)
– as required and depending on the space available (when seat frames are supplied)
The universal interface box is mounted either using Velcro strips or screws.
Mounting using Velcro strips
Stick the two Velcro strips onto the back of the interface box parallel to the top and bottom edges. The
area must be free of dust and grease before attaching the Velcro strips.
Mounting using screws
If screws are to be used, open the cover of the interface box in order to mark the drill points in the
corners of the box. Remove the back or seat padding, drill the holes and insert the drive-in nuts.
Screw on the interface box.
Cable management
The connecting cable plug is inserted in the LCD control box service socket from below. . Lay the
cable in such a way that it is not pinched and use the cable binders to secure it.
12