b
Base cover
3
To remove the battery:
a
Lift the ribbon, and disconnect the battery cable from the connector on the system board [1].
b Remove the M2.0 x 4 L screws that secure the battery to the computer [2].
NOTE:
c
Lift the battery from the computer [3].
Installing battery
1
Insert the battery into the slot on the computer.
2
Connect the battery cable to the connector on the system board.
3
Replace the M 2 x 4L screws to secure the battery to the computer.
4
Install the:
a
base cover
b
SD card
5
Follow the procedure in
PCIe Solid State Drive (SSD)
Removing the NVMe SSD card
1
Follow the procedure in
2
Remove:
a
MicroSD card
b
base cover
c
battery
12
Removing and installing components
The image displayed is for reference only. Some components location and screw may vary.
After working inside your
computer.
Before working inside your
computer.