100W C-Band Transceiver
Installation
Figure 2-4 Looking down
Figure 2-6. CSAT Single-Thread Bracket
with Hardware
Figure 2-5. Installing the Pole Bracket
6. Attach bracket (5, figure 2-1) to the strap (4)
using two nuts (10), two flat washers, (7),
and two splitlock washers (8).
7. Place the assembly against the pole with the
strap around the pole and trim strap (4) to fit
as shown in Figure 2-4, using the tin snips.
8. Attach bracket (3, figure 2-1) to the strap (4)
using two nuts (10), two flat washers (7),
and two splitlock washers (8).
9. Slide tensioner bracket (2) into channel of the
top Unistrut bracket (1).
10. Place assembly on the pole. Slide bracket (3)
over bracket (2).
11. Place flat washer (7) and splitlock washer
(8), and nut (10) on bracket (2).
12. Tighten nut to secure the tension strap.
2-7
Revision 0
MN/CSAT5060100.IOM