Comtech EF Data CSAT-5060 Installation And Operation Manual page 106

CSAT-5060 100W C-Band Transceiver
Index
RED Auto/Manual Signal, B-8
Redund_FLT Signal, B-9
Redundancy A/B Signals, B-9
Redundancy Configuration, 2-11
Redundancy Controller Auto/Manual, 3-8
Redundancy Controller Toggle, 3-8
Redundancy Installation, 2-20
Redundant System, B-1
Reference Frequency Adjust, 3-5
Reference Oscillator Module, C-3
RF Converter Module, C-3
RF Signal Conversion, D-2
RSU-5060 Interfaces, B-2
RSU-5060 Operation, B-7
RX-IF Interfaces, J9-J11, B-6
RX Waveguide Switch Interface, J2, B-3
Set Baud Rate, 3-8
Set Date, 3-9
-R-
-S-
Set Physical Address, 3-8
Set Time, 3-9
Single-Thread Configuration, 2-3
Single-Thread Installation, 2-6
Start of Packet, A-3
Switch CMD Signal, B-8
Temperature Fault, C-4
Tools Required,2–2
Troubleshooting, C-2
Turning on the CSAT, 3-2
TX Amplifier, 3-4
TX-IF Interfaces, J6, J7, and J8, B-5
TX Waveguide Switch Interface, J4, B-4
Upconverter, D-3
Unpacking and Inspection, 2–1
i–2
Revision 0
MN/CSAT5060 100.IOM
-T-
-U-