Controlling The Tv Or The Av Amplifier (Receiver) With The Supplied Remote - Sony DVP-S715 Operating Instructions Manual

Controlling the TV or the AV
Amplifier (Receiver) with the
Supplied Remote Z
If you adjust the remote signal, you can control your
TVs with the supplied remote. Default setting is to
control Sony TVs with the g mark.
When you connect the player to a Sony AV amplifier,
you can also set the input of the amplifier to this player
with the supplied remote .
DVP-S715
1 2 3
4 5 6
7 8 9
0
Controlling TVs with the remote
1
Slide TV/DVD switch to TV.
2
Hold down 1/u, and enter your TV's
manufacturer's code in the table below using the
number buttons. Then release 1/u.
Code numbers of controllable TVs
If more than one code number is listed, try entering
them one at a time until you find the one that works
with your TV.
Notes
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote commander,
the code number automatically resets to 01 (Sony). Reset the
appropriate code number.
Downloaded From Disc-Player.com Sony Manuals
DVP-S315
1/u
TV/DVD
Switch
1 2 3
4 5 6
Number
7 8 9
Buttons
0
Playing CDs in Various Modes
Playing Discs in Various Modes
Manufacturer Code
number
Sony (default) 01
Grundig 11
Hitachi 24
Loewe 45
Nokia 15,16,69
Panasonic 17,49
Philips 06,07,08
Saba 12,13
Samsung 22,23
Sanyo 25
Sharp 29
Telefunken 36
Thomson 43
Toshiba 38
(Continued)
31 GB