Windshield Washers - Jeep Liberty 2008 Owner's Manual

Hide thumbs Also See for Liberty 2008:
Table of Contents

Advertisement

152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Settings (Customer Programmable Features)" under
"Electronic Vehicle Information Center (EVIC)" in
Section 4 of this manual.
The rain-sensing system has protective features for the
wiper blades and arms. It will not operate under the
following conditions:
• Low Temperature Wipe Inhibit — The rain-sensing
feature will not operate when the ignition is first
switched ON, the vehicle is stationary, and the outside
temperature is below 32° F (0° C). If the wiper control
is moved, the vehicle speed becomes greater than 0
mph (0 km/h), or the outside temperature rises above
freezing the rain-sensing feature will then operate.
• Neutral Wipe Inhibit — The rain-sensing feature will
not operate when the ignition is ON, and the shift
lever is in the NEUTRAL position, and the vehicle
speed is less than 5 mph (8 km/h), unless the wiper
control is moved or the shift lever is moved out of the
NEUTRAL position.
• Remote Start Wipe Inhibit (Vehicles Equipped with
Remote Start System) — The rain-sensing feature will
not operate when the vehicle is in remote start mode.
This feature will return to normal operation once
remote start mode is exited. Refer to "Remote Start
System" in Section 2 of this manual for information on
remote start operation.

Windshield Washers

To use the washer, pull the Windshield Wiper/Washer
Control lever toward you and hold it for as long as
washer spray is desired.
If you activate the washer while the wiper control is in
the delay range, the wipers will operate in low speed for
two wipe cycles after releasing the lever and then resume
the intermittent interval previously selected.

Advertisement

Table of Contents
loading

Table of Contents