Jeep Liberty 2008 Owner's Manual page 202

position before engine start. If the light does not turn on
when turning the key from LOCK or ACC to ON, have
the condition checked promptly.
Certain conditions such as a loose or missing gas cap,
poor fuel quality, etc. may turn on the light after engine
start. The vehicle should be serviced if the light stays on
through several of your typical driving cycles. In most
situations, the vehicle will drive normally and it will not
require towing.
If the MIL flashes when the engine is running, serious
conditions may exist that could lead to immediate loss of
power or severe catalytic converter damage. The vehicle
should be serviced as soon as possible if this occurs. (See
page 417 for more information.)
INSTRUMENT PANEL AND CONTROLS 201
CAUTION!
Prolonged driving with the MIL on could cause
damage to the engine control system. It also could
affect fuel economy and drivability.
If the MIL is flashing, severe catalytic converter
damage and power loss will soon occur. Immediate
service is required.
7. High Beam Indicator Light
This light shows that the headlights are on high
beam. Pull the multifunction control lever on the
left side of the steering column toward you to switch to
Low beam. (See page 140 for more information.)
8. Front Fog Light Indicator Light — If Equipped
This light shows when the fog lights are ON. (See
page 140 for more information.)
4