Using The Accessories - AEG KM4400001 User Manual

14 www.aeg.com
SYM-
BOL
Press
change the clock function.
Press
of the clock functions, or wait 5
seconds for the setting to be
confirmed automatically.
7.1 Setting the DURATION or
END
1.
Press
display shows
2.
Press
3.
Press
4.
Press
5.
Press
nal sounds for 2 minutes after the
time ends.
time setting flash in the display. The
oven stops.
6. Press any button or open the oven
door to stop the acoustic signal.
If you press
hours for DURATION
appliance goes to setting of the
END
7.2 Setting the MINUTE
MINDER
Use this to set a countdown (maximum 2
h 30 min). This function has no effect on
the operation of the oven. You can set

8. USING THE ACCESSORIES

WARNING!
Refer to the Safety chapters.
FUNCTION
END
again and again to
to confirm the settings
again and again until the
or
or flashes in the display.
or to the set minutes.
to confirm.
or to set the hour.
to confirm. An acoustic sig-
or symbol and
when you set the
function.
To set when the appliance must be deactivated.
First set an oven function before you set this func-
tion. You can use Duration and End at the same
time (Time Delay) to set the time when the appli-
ance must be activated and then deactivated.
the MINUTE MINDER at any time, also if
the appliance is off.
1.
2.
.
3.
4.
, the
7.3 Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates. It is on immedi-
ately when the oven starts to heat.
To reset the Count Up Timer, press and
hold
DESCRIPTION
Press again and again until
and "00" flash in the display.
Press or to set the MINUTE
MINDER. At first the time is calcula-
ted in minutes and seconds. When
the time you set is longer than 60
minutes, the symbol
the display. The appliance now cal-
culates the time in hours and mi-
nutes.
The MINUTE MINDER starts auto-
matically after five seconds.
After 90% of the set time, an
acoustic signal sounds.
Press a button to stop the signal.
When the set time ends, an acoustic
signal sounds for two minutes.
"00:00" and flash in the display.
Press a button to stop the signal.
If you set the MINUTE MINDER
when the DURATION or END
function operates, the symbol
comes on the display.
and .
You cannot use the Count Up
Timer when Duration or End
function operates.
comes on