Submenu; External Activity Monitor - Funkwerk bintec R230aw User Manual

Purpose
Method of operation
System
2

Submenu

External Activity Monitor

The fields of the E
XTERNAL
R232bw Setup Tool
[SYSTEM]: [ACTIVMON]: External Activity Monitor
Client IP Address
Client UDP Port
Type
Update Interval (sec)
SAVE
➜
The S E A
YSTEM XTERNAL
sary for monitoring your gateway with the Windows Activity Monitor tool (part of
BRICKware for Windows).
The Activity Monitor enables Windows users to monitor the activities of the
gateway. Important information about the status of physical interfaces (e.g.
ISDN line) and virtual interfaces (e.g. WAN partner) is easily obtained with one
tool. A permanent overview of the utilization of the gateway is possible.
A Status Daemon collects information about the gateway and transfers it in the
form of UDP packets to the broadcast address of the first LAN interface (default
setting) or to an explicitly entered IP address. One packet is sent per time inter-
val, which can be adjusted individually to values from 1 - 60 seconds. Up to 100
physical and virtual interfaces can be monitored, provided the packet size of
4,096 bytes is not exceeded. The Activity Monitor on your PC receives the pack-
ets and can display the information contained in them in various ways according
to configuration.
Activate the Activity Monitor
■
Configure the relevant gateway(s) to be monitored.
Submenu External Activity Monitor
A M submenu are described below.
CTIVITY ONITOR
Funkwerk Enterprise Communications GmbH
255.255.255.255
2107
off
5
CANCEL
M menu contains the settings neces-
CTIVITY ONITOR
as follows:
2
MyGateway
bintec User's Guide 7