Security - DFI BPC370-BW User Manual

Smart Fan Function
This section configures the Smart Fan Function.
InsydeH20 Setup Utility
Advanced
Smart Fan Function
SYS Smart Fan1 Control <Enable>
Boundary 1 [40]
Boundary 2 [50]
Boundary 3 [60]
Boundary 4 [70]
Fan Speed Count 1 [10]
Fan Speed Count 2 [15]
Fan Speed Count 3 [25]
Fan Speed Count 4 [255]
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
SYS Smart Fan Control
Enable or disable the smart fan control. If you choose to disable this function, enter
the fan speed (in the fixed speed mode) from 0 (non-operating) to 255 (full-speed).
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the operation of the fan with different
fan speeds accordingly. For example, when the system or the CPU temperature reaches
boundary temperature 1, the system or CPU fan should be turned on and operate at
the designated speed.
The range of the temperature is from 0 to 127
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed. The range is from 0 (non-operating) to 255 (full-speed).
Chapter 3 BIOS Setup
Chapter 7 BIOS Setup
Chapter 7
Rev. 5.0
Enable/Disable Smart Fan
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

o
C.

Security

This section configures the trusted platform module (TPM) function.
Main Advanced Security
Current TPM Device <TPM 2.0 (FTPM) >
TPM State Enabled, UnOwned
TPM Availability <Available>
TPM Operation <No Operation>
Clear TPM []
Supervisor Password Not installed
Set Supervisor Password
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
TPM Availability
Show or hide the TPM availability and its configurations.
TPM Operation
Enable or disable the TPM function. It displays the following options:
• No Operation: No changes to the current state.
• Disable: Disable and deactivate TPM.
• Enable: Enable and activate TPM.
Clear TPM
Remove all TPM ownership contents.
Set Supervisor Password
Set the administrative password for entering the BIOS utility or upon entering the
power-on self-test (POST) process. The length of the password must be greater than 1
character and less than or equal to 10 characters.
Power-on Password
If you select to set the supervisor password, this option will be shown. Enable or dis-
able prompt for password at boot.
37
InsydeH20 Setup Utility Rev. 5.0
Boot Exit
Install or Change the pass-
word and the length of
password must be greater
that one character.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com