Installing The Battery; Battery - Yamaha PW-SE series Original Instructions Manual

INSTRUMENT AND CONTROL FUNCTIONS
Clamp
Display unit
The display unit offers the following operations and infor-
mation displays.

2 Installing the battery

The display needs to be removed and installed for chang-
ing the battery.
• Remove the two bolts on back side of the clamp, and
• When installing the display, tighten the two display
Display bolt
Tighten the display bolts to 1.5–2.5 N·m. During rid-
ing, vibration could cause the bolts to come loose
with the risk that the display may fall off.
TIP
• The clamp and display might be installed on the right
• For models without this clamp, the above note does not

2 Battery

Check if the rated battery (CR2032) is installed in the rear
of the display.
Close
If a battery is not installed, or if there is not sufficient bat-
Cover
tery power remaining, install a new battery.
Waterproof seal
To adjust the time and set the units for distance and
Battery
speed, see "Stopwatch and settings".
TIP
• Make sure that the waterproof seal is installed correct-
• Use a new type CR2032 button cell battery (sold sepa-
• When a battery becomes empty, whenever it turns on
then remove the display.
bolts from the back side of the clamp.
WARNING
side of the stem.
apply.
ly.
rately).
the vehicle power supply, the clock begins to count
from 11:00. Please replace the battery, if such a condi-
tion appears.
14