Adjusting The Display Angle; Power “On/Off” - Yamaha PW-SE series Original Instructions Manual

INSTRUMENT AND CONTROL FUNCTIONS
Clamp bolt

2 Adjusting the display angle

Adjust the display angle by loosening the clamp bolt. The
angle depends on each rider.
After adjustment, tighten the clamp bolt.
WARNING
Tighten the clamp bolt to 3.0–4.5 N·m. During riding,
vibration could cause the clamp bolt to come loose
with the risk that the clamp may fall off.
TIP
• The clamp and display might be installed on the right
side of the stem.
• For models without this clamp, the above note does not
apply.
2 Power "On/Off"
Each time you press the power switch, the power switches
between "On" and "Off".
When you turn on the power, the animation will be dis-
played.
After that, the battery capacity indicator, speedometer, as-
sist power meter, Bluetooth indicator, the function display,
and "STD" of assist mode indicator are displayed.
TIP
• When you turn on the power, the assist mode is auto-
matically set to Standard mode.
• Keep your feet off the pedals when turning on the dis-
play unit. Also, do not start riding immediately after
turning on the display unit. Doing so could weaken the
assist power. (Weak assist power in either of these
cases is not a malfunction.) If you did either of the
above by accident, remove your feet from the pedals,
turn on the power again, and wait a moment (approxi-
mately two seconds) before starting to ride.
15