Skyjack SJIII 3220 Service Manual page 92

Service and Maintenance
Test and Verify Tilt Circuit
Set up button is located on this
Light Indicators
Operations of Tilt Switch
The following describes the LED's and what they
indicate.
Illuminated whenever both tilt
axes are within the specified
degrees of the zero/ home
learned position.
Green LED
Flashes when transitioning in
or out of tilt angle limits, but
built in time delay has not fully
occurred.
Illuminated whenever tilt on one
or more axes is more than the
Red LED
specified degrees out from the
zero/ home position.
On together, no blinking when
Green & Red LED
fault detected.
Tilt Circuit Test
1. Refer to section 2 for test tilt sensor procedure.
SKYJACK, Page 10
face next to harness
SJIII 3220 SJIII 3226 SJIII 4620 SJIII 4626 SJIII 4632
Section 5 - Procedures
SJIII DC Electric
157935