Skyjack SJIII 3220 Service Manual page 90

Service and Maintenance
15. Remove jumper wire between #7 and #19 from
terminal block.
16. Reattach all wires #02 to motor contactor.
17. Reinstall any covers that was removed.
18. Remove chock or wheel blocks.
19. Proceed to Test and Verify Tilt Circuit.
SKYJACK, Page 8
Reprogramming Existing Tilt Switch
Set up button is located on this
Light Indicators
1. Ensure aerial platform is parked on a firm level
surface.
2. Chock or block wheels to keep the aerial platform
from rolling forward or backward.
3. Lower/Raise the platform and secure the scissors
using the maintenance bar. (Refer to Operating
manual for Maintenance Support Procedure)
NOTE
The tilt circuit is only powered when
activating a function.
4. Remove any covers to locate and view the tilt
switch.
5. Disconnect all wires #02 from motor contactor.
6. Install jumper wire between #7 and #19 to
terminal strip.
7. Turn main disconnect switch to " " ON position.
8. Verify switch is powered. (Red or green LED will
be continually blinking)
Red LED
Green LED
SJIII 3220 SJIII 3226 SJIII 4620 SJIII 4626 SJIII 4632
Section 5 - Procedures
face next to harness
Red LED
Green LED
SJIII DC Electric
157935