Storage - Ventrac MT720 Operator's Manual & Parts Drawings

7. Place the mower deck height adjustment handle
into position # 18.
8. Clean and apply grease to the back side of
the rear carrier frame/mower deck slide plates
through the access holes (A) in the carrier frame.
9. Place the mower deck height adjustment
handle into position # 1 and open the main
deck cover shield.
10. Clean and apply grease to the front side of the
rear carrier frame/mower deck slide plates (B).
B
11. Clean and apply grease to the back side of the
front carrier frame/mower deck slide plates (C).
12. If the mower deck is equipped with a hydraulic
flip-up kit, grease the cylinder ends. Wipe off
any excess grease.
A
SERVICE

Storage

Preparing the Mower for Storage
1. Clean the mower deck and frame.
2. Inspect for loose or missing hardware, damaged
components, or signs of wear. Repair or replace
any damaged or worn components.
3. Inspect belts, spindles, and mower blades. Repair
or replace any damaged or worn components.
4. Inspect safety decals. Replace any decals that are
faded, illegible, or missing.
5. Apply grease to all grease points and wipe off
any excess grease.
6. If equipped with hydraulic flip-up kit, inspect
the hydraulic hoses and fittings for damage or
wear. Connections must be tight and leak free.
Replace damaged or worn components.
Removing the Mower from Storage
1. Clean the mower deck to remove any accumu-
lated dust or debris.
2. Inspect the mower as instructed in the daily
inspection section of this manual.
3. Test the mower to ensure all components are
working properly.
C
Service - 23