Lubrication; Storage - Ventrac LM600 Operator Manual & Illustrated Parts List

Lubrication

Lubrication is required at the following locations using
a lithium complex NLGI #2 type grease. Refer to the
maintenance schedule for service intervals.
When greasing the rear roller bearings, if the car-
rier frame is not equipped with access holes, flip the
mower deck up into the service position (See Deck
Flip-Up Procedure section) and raise the mower deck
to the highest cutting height setting to access the
grease fittings.
Rear Roller Bearings
Mower Spindles
Carrier Wheel Pivot & Wheel Axle Bearing
SERVICE

Storage

Preparing the Mower for Storage
1. Clean the mower deck and frame.
2. Inspect for loose or missing hardware, damaged
components, or signs of wear. Repair or replace
any damaged or worn components
3. Inspect belts, spindles, and blades. Repair or
replace any damaged or worn components
4. Apply grease to all grease points.
5. Wipe off all excess grease or oil.
Removing the Mower from Storage
Inspect, clean, and prepare the mower for use.
Service - 21