Call Back When Busy - AVM FRITZ!X PC Manual

Call Back When Busy

For a three-way conference call, proceed as follows:
Lift the receiver of your telephone.
Dial the telephone number of the external party and begin
conversation.
Press the hold button.
Dial „0" followed immediately by the telephone number of
your second external party. You can conduct a conversation
with this second external party while party 1 is on hold.
Enter the key combination illustrated at left.
Conduct the conference call. If either of the outside parties
hangs up, you can continue the conversation with the
remaining party.
End the conference call by hanging up the receiver.
Just as for routing, it is possible to switch back to the origi-
nal party during a conference call. Press the hold button
and the number 2. This ends the conference call and the
party with whom you began the converence call remains
on the line. The second external party is put on hold. Enter
the key combination above again to switch back and forth
between parties.
When you dial an external telephone number and this number
is busy, you will receive a signal as soon as the line becomes
free. Your telephone then rings for 20 seconds as for an outside
call. When you lift the receiver, the telephone number of the
desired party will be dialed automatically.
In some cases this feature must be enabled by the telephone services
provider.
To activate this function, proceed as follows:
You have dialed a telephone number and hear the busy
signal.
Dial the number „5" within 20 seconds.
5 PBX Operation
39