Consultation Hold - AVM FRITZ!X PC Manual

Party 2 Party 2 Party 2 Party 2 Party 2
Party 1 Party 1 Party 1 Party 1 Party 1

Consultation Hold

Party 1 Party 1 Party 1
Party 1 Party 1
Party 2 Party 2
Party 2 Party 2 Party 2
Party 1 Party 1
Party 1 Party 1 Party 1
When the party dialed lifts the receiver, you can conduct a
conversation with party 2.
If party 2's line is busy or if party does not answer, press
the hold button again to return to party 1.
If you wish to return to party 1 after concluding your
conversation with party 2, enter the key combination
illustrated at left. This ends the hold mode.
If you end holding by pressing only the hold button, your line
remains connected to party 2. Charges will continue to accrue
until party 2 closes the connection.
Instead of pressing the key combination, you can simply
hang up to end the connection to party 2. The telephone
then will ring and the connection to party 1 will be re-
established when you lift the receiver.
End the conversation by replacing the receiver.
When you have a new caller on hold, party 2, in addition to a
current conversation with party 1, you can switch back and forth
between conversations as often as you wish. This function is
called „consultation hold."
Proceed as follows for a consultation hold:
You are conducting a conversation with party 1.
Press the call hold button. Party 1 will be put on hold and
you are free to speak with other parties.
To connect with party 2, enter the desired extension
number, or the outside telephone number preceded by „0".
When the party dialed lifts the receiver, you can conduct a
conversation with party 2.
If you wish to return to party 1, enter the key combination
illustrated at left.
Now you are speaking with party 1 again.
5 PBX Operation
37