Specifications
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 14.
Assembly
The only assembly required for the
Demolition Hammer is the positioning of the
Auxiliary Handle around the Cylinder Case.
Page 8
Electrical Input
120 VAC / 60 Hz / 15 A
No Load Blows
1300 BPM
Per Minute
1 Bull Point (included)
Chisels
1 Flat Point (included)
Other
Chisel Grease
Accessories
Carbon Brush Set
For technical questions, please call 1-888-866-5797.
3156787
1. Twist Auxiliary Handle into desired position.
2. Tighten Auxiliary Handle Knob to
fasten Auxiliary Handle in place.
Item 63438