Maintenance - Bauer 1632E-B Owner's Manual & Safety Instructions

Maintenance and Servicing
procedures not specifically explained in this manual must be
performed only by a qualified technician.
NOTE: The Demolition Hammer will cease operation once carbon Brushes are worn.
check Brushes every 100-120 hours and, when necessary, replace them.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning and Maintenance
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• dull or cracked Chisel,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Replacing carbon Brushes and Lubrication
NOTE: The Demolition Hammer will cease operation once carbon Brushes are worn.
check Brushes every 100-120 hours and, when necessary, replace them.
1. Use screwdriver to remove the Carbon Brush Cover.
2. Replace the Carbon Brush in the
Carbon Brush Holder.
3. Replace Brush Cap, Rubber Cap,
and Carbon Brush Cover.
4. Remove the Grease Cover (57) using
Grease Cover Wrench (106) and lubricate
the gearbox using White Lithium Grease
or Molybdenum Grease whenever
replacing the Carbon Brushes.
Page 12 For technical questions, please call 1-888-866-5797.
3. This Tool comes properly lubricated.
Internal lubrication is only needed when
replacing the Carbon Brushes, see below.
NOTE: The Demolition Hammer has airtight
construction, allowing three months of
continuous usage before lubrication is needed.
4. Store in temperatures no lower than 50-60° F.
5. WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Figure H
carbon Brush
cover
Grease
cover
Item 63438