Operation - Bauer 1632E-B Owner's Manual & Safety Instructions

Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Chisels come with or without collars.
Figure B shows installation of a chisel without a collar
(the included chisel is without a collar).
Figure E shows installation of a chisel with a collar.
Mounting chisels without a collar
1. IMpORTANT! Wipe clean, then grease chisel's
shank using included chisel Grease.
Note: Keep chisel shank clean. Do not lay in dirt or dust.
2. Pull the Lock Lever to the side, just
far enough to allow the Chisel to be
inserted, as shown in Figure B.
Flat
Notch
4
Lock
Lever
Figure B
Note: Flat Notch on Collar-less Chisel
must face the Lock Lever.
Page 10
3
For technical questions, please call 1-888-866-5797.
cAUTION! Chisel may be HOT after use. Avoid contact
with skin and use protective gloves to remove.
3. Insert Chisel with the Flat Notch facing the Lock
Lever as far as it will go, as shown in Figure C.
Lock Lever
Figure c
4. Pull the Lock Lever back until it locks the
Chisel into place. See Figure D.
Note: Lock Lever will not lie flat against the chuck.
Figure D
5. When the Chisel is installed, there will be play
along the Flat Notch of the shank. Physically
check that the Chisel is secure before operating.
Item 63438