Operation - Bauer 1967E-B Owner's Manual & Safety Instructions

Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
inserting a Bit in the tool
WarninG! When changing a bit immediately
after use, be careful not to touch the bit. It may be
very hot from use, possibly causing serious injury.
Allow the bit time to cool before handling it.
Workpiece and Work area Set up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
General Operating instructions
tO prEVEnt SEriOuS inJury: Grip the tool firmly in both hands.
1. Select an appropriate bit or attachment
for the job. Insert the bit or attachment
as described in the previous section.
2. Start the tool by pressing the Power Button.
3. Use the Variable Speed Dial to adjust the speed
of the tool. Make sure to use a speed appropriate
to the bit and the material being worked on. In
general, harder materials require faster speeds and
softer materials require slower speeds. Relative
speeds are indicated by the numbers on the Switch.
Page 10 For technical questions, please call 1-888-866-5797.
1. To remove a bit: Pull the bit straight out of
the Collet once the Collet Nut is loose.
To insert a bit: Insert the shank end of the bit
into the Collet once the Collet Nut is loose.
2. Tighten Collet Nut securely using the provided
wrench. Ensure that the spindle lock is
released before turning on the tool.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby
that will present a hazard while working.
5. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
4. Apply the tool bit to the work material as needed.
5. When the task has been completed, stop
the tool by pressing the Power Button
again. Remove the bit or attachment as
discussed in the previous section.
6. Store the tool and its bits and attachments
in their case in a safe location.
Item 57001