Operation - Bauer 19543C-B Owner's Manual & Safety Instructions

Operating instructions
Read the EntiRE iMpORtAnt SAFEty inFORMAtiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO AVOiD SERiOUS inJURy AnD pROpERty DAMAGE:
inspect the area before using the Blower. Remove all hard objects from work area. Do not blow
debris in the direction of people, animals or property. Use both hands when operating Blower.
charging Battery pack
Charge Battery Pack according to the instructions included with the 20 V Bauer
Battery Charger. Battery Pack and Charger sold separately.
Work Area Set Up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
General Operation
cAUtiOn! tO pREVEnt inJURy, wear AnSi-
approved eye protection during use.
Slide a fully charged Battery Pack (sold
separately) into slot on bottom of Inflator/
Deflator until it clicks into place.
Battery
pack
inflating
1. Install the size Nozzle that fits the application.
Refer to Assembly on page 7.
2. Insert the Nozzle into the air port
on the inflatable item.
3. Pull and release the Trigger to start
the Inflator/Deflator. The unit will
continue to run until it is turned off.
4. To stop inflating, pull and release
the Trigger to turn off unit.
Page 8 For technical questions, please call 1-888-866-5797.
2. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
5. Disconnect inflatable and close the item's air port.
6. Turn off unit and remove Battery Pack
after use. Clean, then store the unit
indoors out of children's reach.
Deflating
1. Insert the Large Nozzle into the Deflation Port on
top of the tool. Refer to Assembly on page 7.
2. Insert the Nozzle into the air port
on the inflatable item.
3. Pull and release the Trigger to start
the Inflator/Deflator. The unit will
continue to run until it is turned off.
4. To stop deflating, pull and release
the Trigger to turn off unit.
5. Disconnect deflated item and
close the item's air port.
6. Turn off unit and remove Battery Pack
after use. Clean, then store the unit
indoors out of children's reach.
Blower
1. Install the Large Nozzle.
2. Pull and release the Trigger to start the tool. The
unit will continue to run until it is turned off.
3. Hold Blower with both hands and sweep from side
to side. Pull and release the Trigger to turn off unit.
4. Turn off unit and remove Battery Pack
after use. Clean, then store the unit
indoors out of children's reach.
Item 57166