Assigning Quickdeploy Ip Address To Servers; Modifying Idrac Network Settings For Individual Server Idrac; Modifying Idrac Network Settings Using Racadm - Dell EMC PowerEdge VRTX User Manual

Assigning QuickDeploy IP Address to Servers

The figure here shows the QuickDeploy IP addresses assignment to the servers when there are four half-height servers in VRTX
chassis:
The following figure shows the QuickDeploy IP addresses assignment to the servers when there are two full-height blades in VRTX
chassis:

Modifying iDRAC Network Settings for Individual Server iDRAC

Using this feature, you can configure the iDRAC network configurations settings for each installed server. The initial values displayed
for each of the fields are the current values read from the iDRAC. To use this feature, you must have an Enterprise License.
To modify the iDRAC Network Settings:
1. In the left pane, click Server Overview, and then click Setup. On the Deploy iDRAC page the iDRAC Network Settings
section lists the iDRAC IPv4 and IPv6 network configuration settings of all the installed servers.
2. Modify the iDRAC network settings as required for the server(s).
NOTE: You must select the Enable LAN option to specify the IPv4 or IPv6 settings. For information about the fields,
Online Help .
see the
3. To deploy the setting to iDRAC, click Apply iDRAC Network Settings. Any changes made to the QuickDeploy Settings are also
saved.
The iDRAC Network Settings table reflects future network configuration settings; the values shown for installed servers may
or may not be the same as the currently installed iDRAC network configuration settings. Click Refresh to update the iDRAC
Deploy page with each installed iDRAC network configuration settings after changes are made.
NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more iDRAC server network
configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refresh too soon
may display only partially correct data for a one or more iDRAC servers.

Modifying iDRAC Network Settings Using RACADM

RACADM config or getconfig commands support the -m <module> option for the following configuration groups:
•
cfgLanNetworking
•
cfgIPv6LanNetworking
•
cfgRacTuning
•
cfgRemoteHosts
•
cfgSerial
94