Viewing World Wide Name Or Media Access Control Addresses; Fabric Configuration; Viewing Wwn Or Mac Address Information - Dell EMC PowerEdge VRTX User Manual

NOTE: Note the following:
• If a slot is not selected, FlexAddress is not enabled for the selected fabric.
• When none of the fabrics are selected and a server slot is selected and applied, the following message is displayed No
fabrics selected! FlexAddress will not be used on this chassis. Select both the fabric and
the slot to successfully configure FlexAddress.
• Configuring Flexaddress for slave slot is not allowed. The option is greyed out in the CMC Web interface. The Ethernet
devices associated with the slave slot of the server, inherits the master slot configuration.
4. To save the settings, click Apply.
Configuring FlexAddress for Chassis-Level Fabric and Slots Using RACADM
To enable or disable fabrics, use the following RACADM command:
racadm setflexaddr [-f <fabricName> <state>]
where, <fabricName> = A or iDRAC and <state> = 0 or 1
0 is disable and 1 is enable.
To enable or disable slots, use the following RACADM command:
racadm setflexaddr [-i <slot#> <state>
where, <slot#> = 1 or 4 and <state> = 0 or 1
0 is disable and 1 is enable.
For more information about the setflexaddr command, see the Chassis Management Controller for PowerEdge VRTX RACADM
Command Line Reference Guide.
NOTE: If you purchase the FlexAddress or FlexAddressPlus feature with your Dell PowerEdge VRTX, it is preinstalled and
enabled for all slots and fabrics. To purchase this feature, contact Dell at dell.com.
NOTE: By using the racresetcfg subcommand, you can reset the Flex Address of a CMC to its factory-default setting,
which is "disabled". The RACADM syntax is:
racadm racresetcfg -c flex
For more information about the FlexAddress-related RACADM commands and data about the other factory-default
Chassis Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide
properties, see the
available at dell.com/cmcmanuals.

Viewing World Wide Name or Media Access Control Addresses

The WWN/MAC Summary page allows you to view the World Wide Name (WWN) configuration and Media Access Control (MAC)
address of a slot in the chassis.

Fabric Configuration

The Fabric Configuration section displays the type of Input/Output fabric that is installed for Fabric A. A green check mark indicates
that the fabric is enabled for FlexAddress. The FlexAddress feature is used to deploy chassis assigned and slot persistent
WWN/MAC addresses to various fabrics and slots within the chassis. This feature is enabled on a per-fabric and per-slot–basis.
NOTE: For more information about the FlexAddress feature, see

Viewing WWN or MAC Address Information

You can view the WWW/MAC address inventory of Network Adapters for each server slot or all servers in a chassis. The inventory
includes the following:
• Fabric Configuration
146
About FlexAddress.