Configuring Initial Cmc Network - Dell EMC PowerEdge VRTX User Manual

Configuring Initial CMC Network

NOTE: Changing your CMC Network settings may disconnect your current network connection.
You can perform the initial network configuration of CMC before or after CMC has an IP address. If you configure CMC's initial
network settings before you have an IP address, you can use either of the following interfaces:
• The LCD panel on the front of the chassis
• Dell CMC serial console
If you configure initial network settings after the CMC has an IP address, you can use any of the following interfaces:
• Command line interfaces (CLIs) such as a serial console, Telnet, SSH, or the Dell CMC console.
• Remote RACADM
• CMC web interface
• LCD Panel interface
CMC supports both IPv4 and IPv6 addressing modes. The configuration settings for IPv4 and IPv6 are independent of each other.
Configuring CMC Network Using LCD Panel Interface
You can use the LCD panel interface to set up the CMC network.
NOTE: You can customize the orientation of an LCD display (for rack or tower mode) by keeping the up-down buttons
pressed for two seconds. Alternately, you can also use the right-left buttons. For more information about the buttons
available on a CMC LCD panel, see
1. To start the CMC configuration:
• For a chassis that has not been configured earlier, the LCD Language panel is displayed. On the LCD Language panel,
navigate to the required language using the arrow buttons. When the desired language is highlighted, select the language by
pressing the Center button. The Network Settings panel is displayed.
• For a chassis that has been configured earlier, the Main Menu panel is displayed. From the Main Menu, select Settings and
then Network Settings.
2. On the Network Settings panel, select the required mode of setup:
• Quick Setup (DHCP) — Select this mode to set up CMC quickly using DHCP addresses. For information on configuring
CMC using this mode see Configuring CMC Using Quick Setup (DHCP).
• Advanced Setup — Select this mode to set up CMC for advanced configurations. For information on configuring CMC
using this mode see Configuring CMC Using Advanced Setup.
Configuring CMC Using Quick Setup (DHCP)
To set up a network using the LCD panel interface:
1. From the Network Settings panel, select Quick Setup (DHCP). The panel displays the following message.
About to get DHCP addresses. Ensure CMC network cable is connected.
2. Press the center button to highlight the accept button. Press the center button again to accept the settings or navigate to the
back arrow and the press the center button to go back and modify the settings.
Configuring CMC Using Advanced Setup
1. On the Network Settings panel, if you select Advanced Setup, the following message is displayed to confirm if want to
configure CMC:
Configure CMC?
2. To configure CMC by using advanced setup properties, click the center button selecting the check icon.
NOTE: To skip the CMC configuration navigate to the 'X' icon and then press the center button.
3. If you are asked to select an appropriate network speed, select a network speed (Auto (1Gb), 10Mb, or 100Mb) using
appropriate buttons.
LCD Navigation.
29