Quickdeploy Ip Address Assignments For Servers - Dell PowerEdge FX2 User Manual

Setting
iDRAC IPv6 Gateway
iDRAC IPv6 Prefix Length
Use CMC DNS Settings
3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click Apply
iDRAC Network Settings to deploy the settings to the iDRAC.
The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis.
To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate Using QuickDeploy
Settings. The QuickDeploy network configurations settings are copied into the corresponding fields in the iDRAC Network
Configuration Settings table.
NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more iDRAC server
network configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refresh
early may display only partially correct data for one or more iDRAC servers.

QuickDeploy IP address assignments for servers

The following tables show the way that the QuickDeploy IP addresses assigned to the servers based on the sleds present in the
FX2/FX2s Chassis:
• Two full-width sleds in the chassis:
• Four half-width sleds in the chassis:
• Eight quarter-width sleds in the chassis:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
• Four FM120x4 sleds in the chassis:
NOTE: The Reserved QuickDeploy IPAddresses must be set to 16.
• Top row contains only quarter-width sleds and bottom row contains only half-width sleds:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
76
Description
Specifies the default IPv6 gateway to be assigned to the
iDRACs. The default value is "::".
Specifies the prefix length to be assigned for the IPv6
addresses on the iDRAC. The default value is 64.
Enables the CMC DNS Server settings ( IPv4 and IPv6) that
are propagated to iDRAC when a blade server is inserted in
the chassis.