Incoming Call Beep Menu; Channel Lock Menu (Rts Mode Only) - RTS BP-4000 Technical Manual

Universal Beltpack

Incoming Call Beep Menu

The Incoming Call Beep menu is used to enable and disable whether a beep is heard in the headset when
a call comes into the beltpack.
Available options are On or Off.
The default for this menu is Off.
To configure incoming call beep, do the following:
While in the program menu, navigate to Incoming Call Beep.
1.
[voice prompt] "Incoming Call Beep".
Press the TALK button to enable Incoming Call Beep.
2.
[voice prompt] "On".
OR
Press the TALK button to disable Incoming Call Beep.
[voice prompt] "Off".
Exit the Program Menu (see "Exit Program Menu" on page 20).
3.

Channel Lock Menu (RTS Mode Only)

The Channel Lock menu is used to program whether the BP-5000 has access to one or two channels. It is
also used as a method to switch channels on BP-4000
Available options are Channel 1, Channel 2 or Off.
The default for the BP-5000 is Off.
The default for the BP-4000 is Channel 1.
To configure channel lock, do the following:
While in the program menu, navigate to Channel Lock.
1.
[voice prompt] "Channel Lock".
Press the TALK button to select Channel 1.
2.
[voice prompt] "Channel 1".
OR
Press the TALK button twice to select Channel 2.
[voice prompt] "Channel 2".
OR
Press the TALK button three times to select Reset.
[voice prompt] "Off".
Exit the Program Menu (see "Exit Program Menu" on page 20).
3.
Initial Setup and Configuration 25